期刊文献

Investigation of the wear behavior of FeNi36 alloy cut by WEDM method under different loads 收藏

调查FENI36通过WEDM方法切割的Feni36合金在不同载荷下切割的磨损行为
原文求助 发布源
作者
Ferhat Ceritbinmez [1]; Yusuf Kanca [2]; Ahmet Tuna [3]; Erdoğan Kanca [3]
作者单位
[1]Research and Development Center, Haier Group, Odunpazarı/Eskişehir, Turkey;[2]Faculty of Engineering, Hitit University, Corum, Turkey;[3]Faculty of Engineering and Natural Sciences, Iskenderun Technical University, Hatay, Turkey
关键词
Machinability; WEDM; FeNi36; Wear and friction;
关键词译文
可加工性；wedm;feni36;磨损和摩擦；
页码
136-143
DOI
10.1108/AEAT-06-2023-0155
来源信息
Aircraft Engineering and Aerospace Technology ISSN：0002-2667, 2024年, 96卷, 1期, 136-143页
摘要
FeNi36 (Invar-36) alloy is widely used in the fabrication of molding tools in aerospace industries but there remains a need to improve its wear and friction performance due to its relatively low hardness. The formation of a heat affected zone (HAZ) on the surface of Invar-36 cut by wire electric discharge machining (WEDM) is promising to enhance its tribological properties. This study aims to investigate the tribological performance of WEDM-treated Invar-36 via a ball-on-disk tribometer in dry-sliding conditions.
摘要译文
FENI36（Invar-36）合金广泛用于航空航天工业的成型工具的制造，但由于其硬度相对较低，因此仍然需要改善其磨损和摩擦性能。通过电线电气加工（WEDM）切割的不变36表面上的热影响区（HAZ）的形成有望增强其摩擦学特性。这项研究旨在通过在干燥条件下的球盘摩擦仪来研究经过WEDM处理的invar-36的摩擦学性能。
Ferhat Ceritbinmez [1]; Yusuf Kanca [2]; Ahmet Tuna [3]; Erdoğan Kanca [3]. Investigation of the wear behavior of FeNi36 alloy cut by WEDM method under different loads[J]. Aircraft Engineering and Aerospace Technology, 2024,96(1): 136-143